Version: V1.0 Page
39
of 50
5.2 Battery mounted
• During the lifting process, ensure that the angle between the two cables is not greater than
90°, as shown in the figure below.
• Before installing the battery, make sure that the power supply switch is turned OFF.
• Do not place installation tools, metal parts, or sundries on the battery during installation. After
installation, clean up the battery and its surroundings in a timely manner.
• Do not remove the protective parts of the battery terminals, such as the protective cover or
waterproof cap, when handling the battery.
• Do not move or operate under the forklift arm.
• If you need to move devices manually, ensure that at least four people move the devices
together.
Leave a gap of 30cm above the battery for cable routing.
Reserve a fixed position above the battery to help fix the cable harness to prevent long-term stress
damage.
Operational procedure：
Step 1: According to the design requirements, determine the installation position of the battery on a
flat ground and draw a line mark.
Step 2：Find the hoisting holes, use forklifts, cranes and other transportation tools to transport the
battery cabinet to the designated location, and install it at the marked location.
To Next Page
