Note: 1.The flow rate calculation is based on linear velocity 25m/hr; the minimum salt
consumption for regeneration calculation is based on salt consumption 150g/L (Resin).
2. For civil and domestic use, considering the small height-to-diameter ratio of the resin
layer, the optimal configuration should be selected through experimental verification, and a
smaller salt consumption regeneration flow rate (1~2m/h) is recommended.
3. The F105 control valve is recommended to be equipped with a resin tank with a diameter
of 300 or less.
B. Flow rate characteristic
1).Pressure-flow rate curve(Tested without the bypass valve)
To Next Page
Loading...
