11
allows being 2 meters higher than control valve to arrange drain lines, and be better
not longer than 3 meters, or will have effect on Brine Draw.
●Be sure not connect drain with sewer directly, and leave a certain space between
them (Such as showed in the Figure 8.), avoid wastewater being absorbed to the
water treatment equipment.
⑥ Connect brine tube
a. As Figure 9 shows, insert brine line flow control
into connector, and then put into the O-ring.
b. Slide G3/8 brine tube hose connector over end of
brine tube.
c. Put filter net into the tube and insert tube bushing
into the end of brine tube.
d. Tighten brine draw hose connector onto valve connector, then insert connecter into brine
line connector, finally, insert the clip.
e. Connect the other end of brine tube with the brine tank. (The liquid level controller and
air-blocker should be installed in the brine tank.)
Remark: The brine tube and drain pipeline should not be bended or plugged.
2.Basic Setting & Usage
2.1.The Function of PC Board
A. Button lock indicator
To Next Page
Loading...
