1
Notice
⚫ To ensure normal operation of the valve, please consult with professional installation or
repairing personnel before use it.
⚫ If there are any of pipeline engineering and electric works, there must be finished by
professional at the time of installation.
⚫ Do not use the control valve with the water that is unsafe or unknown quality.
⚫ Depending on the changing of working environment and water requirement, each
parameter of softener should be adjusted accordingly.
⚫ When the water treatment capacity is too low, please check the resin. If the reason is
shortage of resin, please add; if the resin turns reddish brown or broken, please replace.
⚫ Test water periodically to verify that system is performing satisfactorily.
⚫ Sodium used in the water softening process should be considered as part of your overall
dietary salt intake. Contact doctor if you are on a low sodium diet.
⚫ Ensure that there is solid salt all the time in the brine tank in the course of using, when
this valve is used for softening. The brine tank should be added crystalline coarse salt only,
at least 99.5% pure, forbidding use the small salt.
⚫ Do not put the valve near the hot resource, high humidity, corrosive, intense magnetic
field or intense librations environment. And do not leave it outside.
⚫ Forbidden to carry the injector body. Avoid using injector body as support to carry the
system.
⚫ Forbidden to use the brine tube or other connectors as support to carry the system.
⚫ Please use this product under the water temperature between 5～50℃, water pressure
0.15～0.6MPa. Failure to use this product under such conditions voids the warranty.
⚫ If the water pressure exceeds 0.6MPa, a pressure reducing valve must be installed
before the water inlet. While, if the water pressure is under 0.15MPa, a booster pump must
be installed before the water inlet.
⚫ PPR pipes, corrugated pipes, or UPVC pipes are recommended for pipe
installation and aluminum-plastic pipes should be avoided.
⚫ Do not let children touch or play, because carelessness operations may cause the
procedure changed.
⚫ When the attached cables or transformer of this product are damaged, they must be
changed to the one that is from our factory.
To Next Page
Loading...
