MODEL 53515/53615/63515/63615/73515/73615
1
Notice
To ensure normal operation of the valve, please consult with
professional installation or repairing personnel before use it.
If there are any of pipeline engineering and electric works, there must
be finished by professional at the time of installation.
Do not use the control valve with the water that is unsafe or unknown
quality.
Depending on the changing of working environment and water
requirement, each parameter of softener should be adjusted accordingly.
When the water treatment capacity is too low, please check the resin.
If the reason is shortage of resin, please add; if the resin is turn to
reddish brown or broken, please replace.
Test water periodically to verify that system is performing satisfactorily.
Ensure that there is solid salt all the time in the brine tank in the course
of using, when this valve is used for softening. The brine tank should be
added the crystalline coarse salt only, at least 99.5% pure, forbidding
use the small salt.
Do not put the valve near the hot resource, high humidity, corrosive,
intense magnetic field or intense librations environment. And do not
leave it outside.
Forbidden to carry the injector body. Avoid using injector body as
support to carry the system.
Forbidden to use the brine tube or other connectors as support to carry
the system.
Please use this product under the water temperature between 5~50 ℃,
water pressure 0.2～0.6MPa. Failure to use this product is under such
conditions voids the warranty.
If the water pressure exceeds 0.6MPa, a pressure reducing valve must
be installed before the water inlet. While, if the water pressure is under
To Next Page
Loading...
Need help?
General
