Saeco 3P - Residual Risks; Vending Machine Identification; Technical Specifications

English
2.3 Residual risks
The dispensing slot is not protected against accidental
contact of hands with the hot liquid.
2.4 Vending machine identification
The vending machine is identified by the model name and the
registration number, both of which can be found on the
identification tag placed in the lower left part of the back
panel (fig. 2).
The tag bears the following specifications:
• Manufacturer name
• vending machine model
• some constructive specifications:
- power supply voltage (V) power
- supply frequency (Hz) power
absorption (W)
• EC marking
• Registration number
• Year of manufacture
Important
Do not remove or damage the identification tag, as
it's the only element that bears all the information allowing
the Manufacturer to identify the vending machine.
For any demand to the AUTHORIZED SERVICE
CENTRES (assistance, spare parts, etc.) always refer to
this tag, reporting specific vending machine data printed
on it.
2.5
Technical specifications
Size
D.A.5P D.A.3P
W…………………………………….mm 382
D……………………………………..mm 355
H……………………………………..mm 505
Weight…………………………………kg 25 22.5
Installed power……………………….W (*)
Power supply voltage…………………V (*)
Power supply frequency…………….Hz (*)
Supply cable length………………..mm 1500
Capacity
Lyophilized product container……...kg. 0.5 to 1.2
(extractable, transparent)
Coffee container . . . kg. 1.1
(extractable, transparent)
Water tank…………………………litres 4.8
Water supply……………………………. external tank
…………………………… waterworks
connection
Waterworks pressure………………bar 1.5-8
Waterworks connection……………….. 3/4" Gas coupling
(*) See tag on the back of the vending machine
5