English
Danger
The presence of strong magnetic fields or the vicinity of
electric machines generating strong disturbances might
cause malfunctioning of the vending machine electronic
control.
Install the vending machine in a protected environment
with temperatures varying between 10°C and 40°C. Make
sure that no tampering occurred during transportation,
checking that original packaging is intact and closed with
straps. Move the closed box near the installation area
(refer to "3 Handling and storage"), cut the straps and lift
the carton. Verify the state and the model of the vending
machine contained in the carton.
Check the contents of the accessory envelope attached to
the vending machine (refer to "6.2 List of accessory
equipment). Remove the vending machine from the
original packaging. It is advisable to keep the latter for later
transportation or moving. Free the vending machine from
residual packaging.
Important
Possible packaging element disposal shall be performed
in compliance with the laws in force in the country while re-
specting the environment.
Place the vending machine on a horizontal plane surface
having adequate size and capable of standing its weight.
The bearing surface shall not exceed an inclination of 2°.
Important
To ensure proper vending machine ventilation, the
machine's rear panel should be at least 8 cm away from
walls, partitions, etc.
Do not cover the vending machine with cloths or other
things.
6.1 List of accessory equipment
• Micro operation key for safety system deactivation
• 4 screws and nuts for coiner fixing
• Series of stickers with prices and accepted coins
• Series of stickers with instructions and dispensed products
• 1 coupling for water pipe to tank (only for pre-set version
with tank)
• 1 wrench for mix fan fitting
• 1 Operation and Maintenance booklet
8
6.2 Water connection
Machine with tank
(Type D.A. 3P standard e D.A. 5P standard)
- Insert the water aspiration tube in the special
connection under the dispenser (fig. 8).
- Insert the tube in the can.
Machine with direct waterworks connection
(Type D.A. 3P R.I. e D.A. 5P R. .)
- Connect the vending machine to a drinking water
distribution conduit having a pressure between 1,5
and 8 bar. To do this use a loading tube with
adequate characteristics and connect it to the G3/4"
coupling located on the vending machine back
panel (fig. 9).
Important
It is advisable to feed the vending machine with
treated water by means of a decalcifying device,
especially when the water has high calcium and
magnesium salts content (hard water).
6 - INSTALLATION
To Next Page
Loading...
