English
9
101
Although all buttons are
previously programmed on
standard values, check if
the dispensed beverage
has the desired features.
If not, brew buttons must
be reprogrammed (see
chapter “Brew Buttons
Programming”).
If an anomalous condition
occurs during the brewing
phase, e.g. a fault or a
product shortage, a
message indicating the
causes of the block will be
displayed.
Special messages and
signals are indicated in
chapter “Troubleshooting”.
9.6 Steam
(Except for COFFEE set-up)
• Immerse the steam wand into the beverage to be heated.
• Turn the steam dispensing knob counter-clockwise. Once
the required temperature is reached, close the knob
(clockwise).
After each use, clean the
steam wand with a damp,
clean cloth/sponge from
any residues of the
previously heated
beverage.
(*)
Before any brewing cycles, insert the suction tube
inside the milk container.
(**)
Adjust the crema quantity (see section “Crema Adjustment”).
To Next Page
Loading...
