Saeco CAP020B - 9.5 Beverage Selection

English
9
98
9.3 Programmed Automatic
Start-up
This start-up is possible when the machine is in “STANDBY”
mode and the function “AUTOMATIC START-UP” is active.
The machine will switch-on at the programmed time.
9.4 Stand-by Temporary Start-up
Manual switching-on when the machine in “STANDBY” mode.
This is possible by pressing the button shown in the figure for 3
seconds.
The machine will automatically go back to the
“STANDBY” mode after 30 minutes from the last
operation, if still within the programmed standby time.
9.5 Beverage Selection
The conditions necessary to select a beverage are the
following:
• the appliance has reached the set temperature after the
start-up. Otherwise, the display will show the message
“HEATING”;
• There is no error condition that prevents brewing
beverages. Otherwise, the display will show the error
message;
• the selected beverage is enabled. Otherwise, the keypad
shows the beverage off icon;
When dispensing a
beverage:
• The display shows the dispensing beverage icon.