29
English
COIN VALUE
COIN 01: 100
BANKONOTE VALUE
BANKNOTE 01: 5000
MULTIVEND
YES
OVERPAY TIME
000180
PROTOCOL
* EXECUTIVE *
CARD DISCOUNT
100
MAX CARD LOAD
10000
BEVERAGE PREPAR.
BEVERAGE F
BEVERAGE F
SEQUENCE 0 3 C 2
PRICING SYSTEMS
Press ENTER to display the value of the first coin (
COIN 01COIN 01
COIN 01COIN 01
COIN 01). Use the “+”
and “-” buttons to display all the possible coin values that can be set. The
coin value can be changed by pressing ENTER. The blinking cursor
appears. Use the “+” and “-” buttons to modify the value within a pre-
defined range imposed by the nation key.
Press ENTER to display the value of the first banknote (
BANKNOTE 01BANKNOTE 01
BANKNOTE 01BANKNOTE 01
BANKNOTE 01).
Use the “+” and “-” buttons to display all the possible banknote values that
can be set. The banknote value can be changed by pressing ENTER. The
blinking cursor appears. Use the “+” and “-” buttons to modify the value
within a pre-defined range imposed by the nation key.
If “YES” is selected, it is possible to use eventual remaining credit to make
further beverage selections, or to recover the credit through the coin
changer. If “NO” is selected, the remaining credit is collected if the OVER
PAY time has elapsed. The option “MULTI-PRODUCT DISPENSING”
appears only if the Saeco Card system is not available. By pressing ENTER
, the blinking cursor appears. Using the “+” and “-” buttons, you can select
the desired option. then press ENTER to confirm.
It sets the maximum time (in seconds) beyond whict the machine collects the
overpaid money as shown on the display. To modify the time, press ENTER.
The blinking cursor appears. Use the “+” and “-” buttons to change the
current numbers, modifiable in increments of 10 seconds. To disable this
mode, set the values to “
000000000000
000000000000
000000“.
It allows you to choose which protocol should be used to communicate with
the payment systems installed on the machine. Press ENTER to access the
protocol list. Use the “+” and “-” buttons to scroll through the protocol list.
Upon reaching the protocol needed, press ENTER to activate the protocol.
This message appears only if the Saeco Card system is available. It allows
you to award a discount to users purchasing beverages with the Saeco
Card system. Press ENTER to modify the value. The blinking cursor appears.
Use the “+” and “-” buttons to modify the current value. The increments and
range are pre-defined by the nation key.
This message appears only if the Saeco Card system is available. It allows
you to set the maximum credit to be programmed on the Saeco Card. The
programmable range lies between the banknote minimum value (pre-
defined by the nation key) and the maximum credit allowed by the
universal module. Cards with a value higher than the programmed
maximum credit for the machine will not be accepted by the machine.
Press ENTER to enter the second line of the display, where all beverages are
listed. Select the desired beverage (e.g.: F) using the “+” and “-” buttons
and press ENTER to display the first parameter that can be changed. The
selected beverage will always appear on the first line of the display, while the
programmable parameters will appear on the second line. The first
parameter is “
SEQUENCESEQUENCE
SEQUENCESEQUENCE
SEQUENCE”. This message allows you to program the order
in which the products composing beverage F are made and dispensed. By
pressing ENTER, a blinking cursor appears under the number on the far right
of the sequence. Use the “+” and “-” buttons to select which
To Next Page
Loading...
