US English
5
25
Remove the coffee dispensing spout.
Remove the front cover by pushing on its sides to
disengage the fixing elements.
Install the sensor on the inner side of the front cover.
When the sensor has been installed, connect it.
Insert the front cover and fix it by means of the screw
previously removed. Insert the coffee dispensing spout.
Reassemble the drip tray.
Following installation, enable the products dispensed upon
payment and set their price. Access the programming
mode to carry out this procedure.
The machine allows you to
select a price line (0, 1, 2)
whose associated value is
set by the payment system
through a dedicated
software.
To Next Page
Loading...
