Saeco Talea Ring plus - Brew Group Deep Cleaning; Removing the Brew Group; Washing and Reinserting Brew Group

35
1 2 3
4
7 8 9
5 6
Open the service door and remove
the dregs drawer.
The Brew Group must be cleaned at least once a week.
Wash the Brew Group with warm water.
WARNING! Do not wash the Brew Group with detergents that can compromise its correct operation. Do
not wash in the dishwasher.
:DVKWKH%UHZ*URXSDQGWKH¿OWHU
and dry.
Press the PUSH button to remove
the Brew Group.
Insert the washed and dried Brew
Group. DO NOT PRESS THE
“PUSH” BUTTON.
Make sure the Brew Group is in
rest position; the two references
must match.
Close the service door.
Insert the dregs drawer.
CLEANING THE BREW GROUP.
Make sure the components are in
the correct position. The hook shown
must be in the correct position; to
FKHFNLWVSRVLWLRQ¿UPO\SUHVVWKH
“PUSH” button.
The lever on the rear part of the
group must be in contact with
the group base.