2.Rainfall. Press the CHANNEL/+ or MIN/MAX/- key to toggle between 1h, 24h, week,
month and total.
To clear the total rain, press the CHANNEL/+ or MIN/MAX/- button until total rain is
displayed. The total rain will flash. Press and hold the SET button for three seconds until
total rain reads 0.0.
3.Absolute Pressure and Relative Pressure. Press the CHANNEL/+ or MIN/MAX/- key
to toggle between absolute pressure and relative pressure.
4.Outdoor dew point .Press the CHANNEL/+ or MIN/MAX/- key to toggle between
temperature, dew point and feels like
7.2 Set (Program) Mode
While in Normal Mode, Press and hold the SET key for at least three seconds to enter the
Set Mode. The first setting will begin flashing. You can press the SET key again to skip
any step, as defined below.
Note: In the Set mode, press the [+] key or [-] key to change or scroll the value. Hold
the [+] key or [-] key for three seconds to increase/decrease rapidly.
Note: To exit the Set mode at any time, press the SNOOZE button of the display
console.
1. 12/24 Hour Format (default: 24h):.Press the SET key again to adjust the 12/24 hour
format setting (FMT). Press the [+] key or [-] key to change between 12 hour and 24
hour format.
2. Change Hour. press the SET key again to set the hour. Press the [+] key or [-]key to
adjust the hour up or down. Note the PM icon is present during afternoon hours.
3. Change Minute. Press the SET key again to set the minute. Press the [+] key or [-] key
to adjust the minute up or down.
4. Date Format (default: MM-DD): Press the SET key again to enter the day/month
format mode. Press the [+] key to switch between M-D, D-M.
5. Change Month. Press the SET key again to set the calendar month. Press the [+] key
or [-] key to adjust the calendar month.
6. Change Day. Press the SET key again to set the calendar day. Press the [+] key or [-]
key to adjust the calendar day.
7. Change Year. Press the SET key again to set the calendar year. Press the [+] key or
[-] key to adjust the calendar year.
8. Max/Min Clearing (default: ON). Press the SET key again to set the max/min
clearing mode (CLR). The Max/Min can be programmed to clear daily (at midnight) or
manually. Press the [+] key or [-] key to switch between “Clears 24h” and Clears
Manually.
9. Temperature Units of Measure (default: °C ):. Press the SET key again to change the
temperature units of measure (the UNITSET icon will be displayed). Press the [+] key
or [-] key to switch between °F and °C units of measure.
10. Barometric Pressure Display Units(default: hPa). Press the SET key again to
change the pressure units of measure. Press the [+] key or [-] key to toggle the pressure
units between mmHg, inHg or hPa.
11. Pressure Threshold Setting (default level 2). Press the SET key again adjust the
Pressure threshold setting. Press [+] key or [-] key to adjust the pressure threshold
setting up or down.
12. Weather Forecast Icon Setting (default: partly cloudy). Press the SET key again to
set the weather forecast icon initial conditions (based on the current weather
conditions). Press the [+] key or [-] key to toggle weather icons between sunny, partly
cloudy, cloudy, or rainy.
To Next Page
Loading...
