ADJUSTABLE BACKLIGHT BRIGHTNESS
There are 3 levels of brightness of backlight. When the backlight is on press SNOOZE key
to switch between the 3 levels.
Press and hold the LIGHT key for two seconds, and the backlight will turn on
permanently, and display BL ON icon will be displayed for three seconds in the time field.
To turn off the backlight at any time, Press and hold the SNOOZE/LIGHT key for two
seconds, and BL OFF icon will be displayed for three seconds in the date field.
Note: If plugged into AC power, the backlight will remain on. It is not recommended
leaving the backlight on for a long period of time when operating on batteries only, or the
batteries will run down quickly.
8.Alarm Mode
The FT0835 includes the following alarms:
Time(Alarm1 and Alarm2)
Wind Gust
Wind Average
Outdoor Temperature
Outdoor Humidity
Outdoor Feels Like Temperature
Outdoor Dew Point
Hourly Rainfall
24 Hour Rainfall
Absolute Pressure
Relative Pressure
Indoor Temperature
Indoor Humidity
8.1 Alarm Operation
When an alarm condition is exceeded, the alarm icon will flash (visual) and the alarm
beeper will sound (audible). To silence the beeper, press any key.
8.2 Viewing the High and Low Alarms
To view the current alarm settings, press the ALARM key to enter the alarm mode. HI will
be displayed in the time area. At the same time Alarm time parameters of out/indoor
temperature/humidity, rain, feels like, wind gust, wind average, and dew point are
displayed.
Press ALARM key again to view the LOW alarms along with the alarm clock time the
same way HI alarms.
Press the SNOOZE key at any time to return to the normal mode.
8.3 Setting the Alarms
Press ALARM key to enter the alarm mode.
Next, Press and hold the SET key for three seconds. The first alarm parameter will begin
flashing (alarm hour).
To save the alarm setting and proceed to the next alarm parameter, press(do not hold) the
SET key.
To Next Page
Loading...
