13. Location division.(default: Northern Hemisphere) Press the SETkey again to
change the location division. Press the [+] key or [-] key to toggle the sunlight units
Northern Hemisphere (NOR)or Southern Hemisphere(SOU).(refer to 5.0 Final
Installation of Integrated outdoor transmitter)
7.3 Sensor Search Mode
If Outdoor sensor loses communication, dashes (--.-) will be displayed.
To reacquire the lost signal, press and hold the CH/+ button for 3 seconds to enter the
sensor search mode.
7.4 Reset Min/Max record
Note: The minimum and maximum value of all channels will be cleared in the reset
mode.
In normal mode, Press (do not hold) the MIN/MAX/-key, and the MAX icon will be
displayed. Press the SET key to view rainfall (1h, 24h, week or month) , pressure (ABS or
REL) max value ,outdoor temperature (temperature, dew point or feels like).
Next, press and hold the MIN/MAX/- key for three seconds(and the CLR character is
flashing in time area) to clear the rainfall, wind speed, wind gust, pressure, temperature and
humidity maximum values. The maximum values will now display the current values.
Press the MIN/MAX/- key again (do not hold), and the MIN icon will be displayed. Press
the SET key to view pressure (ABS or REL) min value, pressure (ABS or REL) min
value ,outdoor temperature (temperature, dew point or feels like).
Next, Press and hold the MIN/MAX/- key for three seconds(and the CLR character is
flashing in time area) to clear the pressure, temperature and humidity minimum values.
The minimum values will now display the current values.
Press the SNOOZE key to exit the min/max checking and cleaning mode, return to normal
display mode.
7.5 Snooze Mode
If the alarm sounds, and you wish to silence the alarm, press the SNOOZE key, the
backlight will turn on. The alarm icon will continue to flash and the alarm will silence for
five minute. press any key (MIN/MAX/+ ,SET, ALARM,CHANNEL/+) to permanently
exit the Snooze mode.
7.6 Back light Mode
If the LED is off, Press the SNOOZE button once. The backlight will turn on for five
seconds, and if no operation is performed for three seconds, the backlight will turn off.
The backlight operation is different when operating on batteries to save power.
To Next Page
Loading...
