H1 Series
4.4.2 Drill Holes and Place the Expansion Tubes
Following the given guides, drill 4 holes in the wall (in conformity with
position marked in Figure 4.4, and then place expansion tubes in the holes
using a rubber mallet.
Figure 4.4 Drill holes dimensions of H1 inverter
4.4.3 Mount the Screws and the Rear Panel
The panels should be mounted in the mounting position by screws as shown
in Figure 4.5.
Figure 4.5 Mount the Rear Panel of H1 inverter
To Next Page
Loading...
