SAJ H1 Series - First Run Setup; Start Up Inverter

H1 Series
- 37 -
C
Communication
status
When a Wi-Fi/ 4G module is
connected or inverter is upgrading:
Yellow and blue light flashing
alternatively
Table 6.1 Instructions of the Interface
Button
Function
E
A step up / left or increasing the setting value
F
A step down / right or decreasing the setting value
D (ESC)
Press time shorter than 2
seconds
Return to main menu or
canceling the setting
Press time longer than 2
seconds
Cut off output to load
G (ENT)
Press time shorter than 2
seconds
Enter the sub-menu or
confirming a selection
Press time longer than 2
seconds
Turn on output to load
Table 6.2 Instructions for buttons
6.2 First Run Setup
6.2.1 Start Up Inverter
The H1 inverter can be start up by the following procedure:
1. Turn on the external AC switch (grid side)
2. Turn on the DC switch on the inverter
3. Turn on the battery switch between inverter and battery