SAJ Suntrio Plus Series User Manual

Suntrio Plus Series
-
51
-
57
Data Consistency of GFCI Slave
58/59/60
L1/L2/L3 Data Consistency of DCI Slave
61/63/65
L1/L2/L3 Grid Voltage High Slave
62/64/66
L1/L2/L3 Grid Voltage Low Slave
67/69/71
L1/L2/L3 Frequency High Slave
68/70/72
L1/L2/L3 Frequency Low Slave
73/74/75
L1/L2/L3 No Grid Error Slave
76/77/80
PV1 /PV2/PV3 Voltage High Slave
78/79/82
PV1/PV2/PV3 Current High Slave
81
Lost Communication Between Display board & Control
board Master
83
Grounding detect Error Master
84
PV Input Error Master
Table7.1 Error Code
General troubleshooting methods for inverter are as follows:
Table 7.2 Troubleshooting
Error
Troubleshooting
Relay Error
If this error occurs frequently, please contact your distributor or
phone SAJ.
Storer Error
If this error occurs frequently, please contact your distributor or
phone SAJ.
Temperature High
Error
Check whether the radiator is blocked, whether the inverter is in
too high or too low temperature, if the above mentioned are in
normal, please contact your distributor or phone SAJ.
GFCI Device Error
If this error occurs frequently, please contact your distributor or
phone SAJ.
DCI Device Error
If this error occurs frequently, please contact your distributor or
phone SAJ.
Current Sensor
Error
If this error occurs frequently, please contact your distributor or
phone SAJ.
AC Voltage Error
·Check the connection between the inverter and the grid.
·Check the settings of the on-grid standards of the inverter.
·If the volt of the grid is higher than the volt regulated by local
grid, please inquire the local grid workers whether they can
adjust the volt at the feed point or change the value of the
regulated volt.

SAJ Suntrio Plus Series Specifications

General

Brand	SAJ
Model	Suntrio Plus Series
Category	Inverter
Language	English