7
Figure 3.5
4) Carefully attach the inverter to the rear panel according to the position of the screws.
Make sure the backside of the inverter is closely against the rear panel. When two people
transport the inverter, make sure each one use the hand grip in right position as
illustrated in the picture.
Figure 3.6
5) Pay attention to the four notches cut in both flanks of heat sink (as illustrated in above
picture), which should be placed in corresponding hooks from the rear panel. Make sure
that the heat sink and the rear panel are buckled together and the inverter is tightly
attached to the rear panel. And tighten the screws with 5.9N·m torque.
Figure 3.7
6) Please carefully check the accessories and original carton to make sure during the
installation every necessary part is used and nothing is missing.
To Next Page
Loading...
Need help?
General
