SOFTWARE CONFIGURATION
Performing a Test Print
A test print must be performed to ensure the print head
works correctly.
To initiate a test print
1.
Fill a magazine with slides and insert it into magazine
position 1.
2. Press and hold the
[CLEAN]
key until 00 is displayed.
Release the key and a slide is printed with a test image
(Figure 3-A). If the print result is not satisfactory and
the words “Test Print” are not legible and/or the bar
code graphic is not clear, repeat the test print
sequence until the printing quality is acceptable.
NOTE:
The test print can be performed without the printer
connected to a computer.
Figure 3-A
NOTE
: If it is not possible to print an acceptable test print,
refer to Section 7, Troubleshooting, for possible problem
resolution.
To Next Page
Loading...
General