Revised 3/30/2010 1.1
Section 1
INTRODUCTION
Safety Precautions
Operation of the Tissue-Tek
®
Glas
™
g2 Automated
Glass Coverslipper requires expert knowledge of the
target application as well as method of use. To use the
system correctly and safely, designate a “Lead System
Operator.”
When the system is delivered, the Lead System
Operator should receive explanation on the handling of
the system directly from the sales representative.
• Read this “Safety Precautions” section
beforehand to ensure the correct use of the
system.
• The cautionary instructions provided herein are
intended to ensure that the system will be used
safely in a manner preventing the operator from
injury and property damage. These instructions
provide important safety information that must be
heeded at all times.
• Images shown in the manual may partially differ
from those of the actual product.
• In this manual, instructions pertaining to different
levels of potential hazards are classified as
warnings, cautions, and notes and are indicated
under “Warning,” “Caution”, and “Note,”
respectively. Each class of instructions is defined
below.
NOTES, CAUTIONS, WARNINGS, and other safety
related labeling are provided throughout this manual
to indicate levels of potential hazards as defined
below:
NOTE Indicates a reminder or other helpful
information.
CAUTION Indicates a potential hazard in which
failure to follow instruction may result in
damage to the Tissue-Tek
®
Glas
™
g2
and/or other property, or may give poor
processing results.
WARNING Identifies a potential hazard in which
failure to follow instructions may result in
serious injury to the operator and/or
other personnel.
The symbols used on the labels attached to the
system are explained below. Labels bearing one of the
following symbols provide particularly important
information to know in order to ensure safety of the
operator, improve work efficiency, and protect the system
from damage. Be sure to check these labels and
understand the specified instructions before commencing
any work.
HOT SURFACE Indicates hot surfaces. Take precautions
to prevent burns.
BIOHAZARD Possibility of infections depending on
the type of specimens processed.
Prevent infections by using Personal
Protective Equipment (PPE) as required
by OSHA and any applicable state or
local regulations.
A label bearing this symbol specifies a
cautionary item. Improper handling
against the instruction may put the
operator in danger or damage the
system. Always follow the instructions.
A label bearing this symbol specifies an
action that must be taken. Always
follows the instructions.
A label bearing this symbol specifies a
prohibited item. Always follow the
instructions.