The RT310RF from SALUS Controls is a stylish and
accurate digital thermostat with an easy to read Liquid
Crystal Display (LCD).
The Receiver is used for wiring connections and heat on/
off control. The thermostat provides the user interface
and temperature sensing / control. The two units are
linked together by a Radio Frequency (RF) signal.
Features
Frost protection
Low-Battery Warning
Low-Battery Detection
Modern Casing
Sleep Mode
User Friendly
Pre-Paired in Factory
RF Test Pairing
Features
Installation
The DIP switches are found on the rear of your thermostat and can be used to change the span (temperature
accuracy) of your thermostat from the default +/-0.5°C to +/-0.25°C. This may cause your boiler to operate
more frequently. The DIP switches are located on the back of the thermostat. ON +/-0.25°C, OFF +/-0.5°C.
The span is the accuracy with which the thermostat operates when displaying your temperature. You can
increase the accuracy by setting the span to +/-0.25°C, meaning that your thermostat will be sensitive to a
quarter of a degree temperature change and will activate/deactivate the boiler.
DIP switch settings
+/-0.25
+/-0.5
ON
2
Note: Please insert batteries into the RT310RF thermostat and it will power up..
RT310RF Installation Manual 05
To Next Page
Loading...
Need help?
General
