MANUAL OVERRIDE SETTING
When the ST620RF is in NORMAL mode, press the Touch Ring anywhere except the
OK and Arrow keys to enter the Manual Override mode. The currently set
temperature will be displayed on the LCD and will flash.
When the set temperature is flashing, press the Touch Ring and move your finger clockwise to increase the set
temperature, or anti-clockwise to decrease the set temperature. Press OK at any time to confirm the selection. Note
that the set temperature display will not flash while being adjusted – this is normal and the display will start to flash
again approximately 0.5 seconds after the Touch Ring is released. The ST620RF will go back to NORMAL mode
without changing the set temperature after 10 seconds of inactivity, or after pressing the Arrow key.
When the ST620RF is operating in Manual Override mode, the LCD will display MANUAL
instead of AUTO. The manual setting will remain in effect until the next programme
time is reached, programme or clock settings are changed, an operating mode change
is detected or the Manual Override mode is cancelled.
Manual Override mode can be cancelled at any time by pressing and holding the Arrow
key for 2 seconds – this will return the ST620RF to AUTO mode.
If the ST620RF is in Frost,or Holiday or Service mode, the set temperature can't be adjusted, only can be reviewed.
ST620RF INSTRUCTION MANUAL28
To Next Page
Loading...
