SALVA INDUSTRIAL, S.A Horno Sirocco 00 Gas-Gasoil 50-60Hz (ing)121206.doc
1-2
1. PREASSEMBLY INSTRUCTIONS
1.1 STORAGE AND TRANSPORT
The oven is sent disassembled or fully assembled, but is always sent packed on a wood platform,
and covered with plastic film, that protects the machine against humidity and rain.
The oven should be transported in a completely closed vehicle, and it should never be left
outdoor.
1.2 CONDITIONS FOR USE
• The oven has been manufactured to be installed indoor. It is not made to work outdoor. Any
possible contact with water has to be avoided.
• The oven should not be installed in places with excessive heat, steam and/or humidity production.
• The oven is prepared to work under the following external conditions: -10 + 40 ºC, and 0 + 90 %
of humidity.
• The room in which the oven has to be installed must have adequate ventilation. If there is a
fumes extractor, then a window with at least the section of the fumes extractor should be kept
open.
• The position of the oven regarding the side and back wall of the installation premises should have
a minimum distance of 2" (50 mm) between the oven sides and the walls of the room.
VERY IMPORTANT
The base on which the oven is fitted has to be of a nonflammable material and able to withstand a
constant temperature of 300º C (572 ºF) without deteriorating.
To Next Page
Loading...
