Sam4s ER-260 SERIES - 3-3 Operation Modes and Functions

3. Installation and Operation
SAM4S ER-260 SERIES 3-5
3-3 Operation
Note: Before using this Electronic Cash Register (ECR) for the first time, leave it powered ON in the REG mode
for a at least 24 hours. This allows the Ms-Lithium battery, which maintains the ECR’s memory while the
power is OFF, to fully charge.
3-3-1 Mode Switch
The position of the Mode Key determines the action of the ECR. The modes are as shown in Table 3-3
Figure3-5 Mode Switch Table3-3 Mode Switch Function
The mode switch can be used to access the following key lock positions.
Mode Accessible Position Remark
VOID Void, Off, Register(REG), Manager(X)
REG Off, Register(REG)
X Off, Register(REG), Manager(X)
Z Off, Register(REG), Manager(X), Clear Totals(Z)
PGM Void, Off, Register(REG), Manager(X), Clear Totals(Z), Program(P)
S Void, Off, Register(REG), Manager(X), Clear Totals(Z), Program(P), Service Mode(S)
Table3-4 Key Function
Note : The Key can be removed from the key lock in the OFF or REGISTER position.
Mode Key Function
VOID VD Use to void (correct) items outside of a sale.
OFF - The Register is inoperable.
REG REG Use for normal registrations.
X X Use to read register reports and perform other manager functions.
Z Z Use to read register reports and reset totals to zero.
PGM P Use to program the register
S C Use for H/W tests and special setting.