Sam4s ER-260 SERIES - Initial Clear

3. Installation and Operation
SAM4S ER-260 SERIES 3-7
3-3 Operation
3-3-3 Initial Clear
1. Unplug the register.
2. Turn the control lock to the “S” position.
3. Press and hold the key position where the “CASH” key is located on the default keyboard layout.
4. While continuing to hold the “CASH” key, plug the register into a power source.
5. The message "****** INITIAL CLEAR ******” prints when the initial clear is complete.
Figure3-8. Initial Clear Key & Print Sheet(ER-260)
****** INITIAL CLEAR ******