Sam4s ER-260 SERIES - 2 Product Specifications; 2-1 General Specifications

SAM4S ER-260 SERIES 2-1
2 Product Specifications
Specifications are correct at the time of printing. Product specifications are subject to change without notice.
See below for product specifications.
2-1 Specifications
Item Description Remark
Processor
WINBOND CPU W78C438 (8-Bit)
Memory
• RAM
SRAM (K6T1008C2E) : 1MBITs (Default)
SRAM (K6T4008C2E) : 4MBITs (Option)
• ROM
EPROM(27C2001) : 2MBITs (Default)
• FISCAL ROM
EPROM(27C1001) : 1MBITs (Default)
EPROM(27C2001) : 2MBITs (Option)
Battery
• Type : MS Lithium, 3.0V 11mAh
• Part Name : MS920S
• Charging Time : 24 Hours
• Life : 3 Years
Data Storage
• 60 Days
When battery is Full charged
Interface Serial
(RS-232C)
• Flow Control :
① DTR / DSR : H/W Flow Control
• Baud Rate : 9600 Bps
• Connector : DB9P Female (I/F PBA)
• Voltage Supply : VCC(+5V/150mA) supplies at 9Pin of Connector.
Printer
• Model : LTP8235 (SII)
• Print Speed : 30mm/Sec, 8Line/Sec
• Type : Thermal Dot Line Printing
• Resolution : 150 dpi (6 Dot)
• Paper End Sensor (Photo Sensor)
Detail Spec refer to Next
Page
Display
• Operator Display : 10 Digits VFD or LCD(16 * 2Line Character Type)
• Customer Display : 10 Digits VFD (Option)
Keyboard
• 49-Key (Raised Type): ER-260
• 49-Key (Flat Type) : ER-265
• 3B4C / 4B4C
Small Drawer
Drawer
• 5B5C / 4B8C / 7B8C
Middle Drawer
Power Consumption
• Regularity : Approx. 20W
Power Requirement
• AC 120V 60Hz, 230V 50Hz
Environment
Condition
• Temperature : 0℃ ~ 45℃
• humidity : 30% ~ 80% RH
Dimensions(mm)
• 325(W) X 420(D) X 226(H)
With Small Drawer
Weight
• 7.4 Kg (Set Only), 8.6Kg (with Packing)
With Small Drawer
Table2-1 General Specifications