SECTION IV WHEELS
Tyre inflation pressures
- Tyres for front 4WD: 1.6 bar (23 psi)
- Rear tyres: 1.3 bar (19 psi)
For the tyre bead to seat correctly on the rim, the inflation pressure must
never exceed 5 bar (72.52 psi). Higher inflations pressures may cause the
tyre/rim to explode.
We recommend the use of metal safety cages or tyre restraint bars when
carrying out operations that require tyre inflation pressures above the
values for normal use.
IMPORTANT - When working on agricultural land in conditions requiring
maximum grip, the rear tyre inflation pressure may be reduced to a
minimum of 0.8 bar (11.60 psi). The normal inflation pressures for front
and rear tyres are those reported in the specifications table. These values
may be reduced proportionally to the permitted limits when necessary to
ensure a correct mechanical match between the front and rear wheels.
Narrow track
– at rear
Depending on the given tire size, not all of the shown track widths are
suitable for your tractor, as tire and fender may interfere. When selecting
the track width, make sure that there is adequate clearance between
fender and tire.
– at front
If you combine a narrow front axle track width with wide tires, watch out
that this does not block too much the steer angle. Check the distance
between engine hood and fenders. For this purpose, turn front wheels
against lock, then move front wheels up and down and let axle swing.
92
WARNING: FOR THE TYRE BEAD TO SEAT CORRECTLY ON THE
RIM, THE INFLATION PRESSURE MUST NEVER EXCEED 5 BAR (72
PSI).
HIGHER INFLATIONS PRESSURES MAY CAUSE THE TYRE/RIM TO
EXPLODE.
WE RECOMMEND THE USE OF METAL SAFETY CAGES OR TYRE
RESTRAINT BARS WHEN CARRYING OUT OPERATIONS THAT RE-
QUIRE TYRE INFLATION PRESSURES ABOVE THE VALUES FOR
NORMAL USE.
To Next Page
Loading...
Need help?
General
