SECTION V MAINTENANCE
Important notes
–
Ensure that any containers used to store lubricants are perfectly
clean. Funnels and measuring cups must be covered to prevent dust
settling on them.
–
Clean the areas adjacent to the parts to be lubricated.
–
Grease parts when warm so that the grease flows more easily.
–
Clean all plugs and caps before replacing them.
–
Fuel tank capacities are indicated in the table on the opposite page.
–
Carry out all operations in accordance with the instructions given and
the applicable safety regulations.
–
Before starting work on the tractor, make sure the engine is switched off,
the key is removed from the ignition and the handbrake is applied.
–
Only work with the engine running when this is specifically indicated in
the instructions.
113
WARNING: DO NOT REMOVE OR OBSCURE DANGER, WARNING,
CAUTION OR INSTRUCTION DECALS. REPLACE ANY DANGER,
WARNING, CAUTION OR INSTRUCTION DECALS THAT ARE NOT
READABLE OR ARE MISSING. REPLACEMENT DECALS ARE AVAIL-
ABLE FROM YOUR DEALER IN THE EVENT OF LOSS OR DAMAGE.
THE ACTUAL LOCATION AND ORDERING CODE OF THESE SAFETY
DECALS IS ILLUSTRATED AT THE END OF THIS SECTION. WHEN
YOU REPLACE A PART THAT CARRIES A SAFETY LABEL, MAKE
SURE THAT THE SAME LABEL IS APPLIED TO THE NEW PART. DO
NOT USE FUEL OR SOLVENTS ETC. TO CLEAN SAFETY LABELS.
USE A CLEAN CLOTH DAMPED IN SOAPY WATER.
WARNING: BEFORE STARTING THE ENGINE MAKE SURE THERE IS
PLENTY OF VENTILATION. DO NOT OPERATE THE ENGINE IN A
CLOSED BUILDING. THE EXHAUST FUMES MAY CAUSE ASPHYXIA-
TION.
To Next Page
Loading...
Need help?
General
