What to do if powder does not adhere to the part with Sames Paint Sprayer?
If the powder doesn't adhere to the part, check the three high-voltage unit connections to ensure they are correctly connected. If there is a low-voltage cable cut off, replace it. Also, ensure that the U/I and pneumatic adjustments are set to the factory settings.
Details the technical regulations and standards the spray gun conforms to.
Outlines essential safety rules for operating the equipment to prevent hazards.
Information regarding the guarantee period and conditions for the control module.
Lists the technical specifications for the spray gun and control module.
Specifies the required quality characteristics for the compressed air supply.
Details the various connection ports on the back of the CRN 457 control module.
Explains the information found on the control module's identification plate.
Explains the functions and controls accessible directly from the spray gun.
Details the functions and menus accessible via the CRN 457 control module front panel.
Summarizes key operations and settings for the spray gun and control module.
Describes the initial screen displayed upon starting the CRN 457 control module.
Explains the start-up screen for manual units, with or without PLC connection.
Details the operation and use of the cleaning screen on the control module.
Explains the standby screen and its function when connected to a PLC.
Describes the main screen for parameter selection and spray gun operation monitoring.
Details screen B for adjusting dilution air and selecting voltage/current characteristics.
Explains how to modify voltage and current settings using screen C.
Displays the history of faults encountered, including a detailed fault list.
Explains how to adjust screen contrast and reverse screen colours.
Used to select the powder supply mode (vibrating table or fluidisation tank).
Consults adjustment parameters for remote mode when connected to a PLC.
Used to select between U/I₁ and U/I₂ characteristic types for painting.
Instructions for disassembling and assembling the deflector and nozzle.
Procedures for disassembling and assembling the vertical powder pipe.
Details the disassembly and assembly of the powder elbow and horizontal pipe.
Instructions for disassembling and assembling the gun's handle assembly.
Procedures for disassembling and assembling the spray gun trigger.
Instructions for disassembling and reassembling the hand-rest.
Procedures for disassembling and assembling the main gun body.
Detailed steps for disassembling and assembling the cable assembly with care.
Lists spare parts for the Mach-Jet Spray Gun with item numbers and references.
Lists spare parts for the Gun assembly with item numbers and references.
Lists spare parts for the Handle assembly with item numbers and references.
Lists spare parts for the Vertical powder pipe assembly with item numbers and references.
Lists various types of nozzles (fan, round, extended) and related parts.
Lists additional equipment and tools, including power cables and flush filters.
General| Brand | Sames |
|---|---|
| Model | Mach-Jet |
| Category | Paint Sprayer |
| Language | English |
To Next Page