EasyManua.ls Logo

Sames Mach-Jet - 3.2. Compressed air quality

Sames Mach-Jet
47 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Index revision : H 9 6336
3.2. Compressed air quality
Required characteristics for compressed-air supply according to standard NF ISO 8573-1:
*: Values are given for a temperature of 0˚ C (32˚ F) at an atmospheric pressure of 1,013 mbar.
WARNING : Non-compliance with these characteristics may result in incorrect operation of the
“CRN 457” control module.
WARNING : A 5µµ
µµ
filter must be installed upstream of the “CRN 457” control module compressed-
air supply system. The size of this filter depends on the size of the installation.
Sames Technologies advises to use a filter like the one indicated in section
(see § 10.6 page 46).
If any damage on the equipment happens because of a polluted air, the warranty could be not
applied.
Maximum dew point at 6 bar (90 psi) Class 4, i.e. +3˚ C (38˚F)
Maximum particle-size of solid pollutants Class 3, i.e. 5
µ
m
Maximum oil concentration
Class 1, i.e. 0.01 mg/m
0
3
*
Maximum concentration of solid pollutants
Class 3, i.e. 5 mg/m
0
3
*