Index revision : H 16 6336
5.3. Summary
• Selection of U and I pre-programmed characteristics (from spray gun or control module) is only
possible if the operator is not painting.
• Powder flow rate is adjustable (high voltage activated or not):
• From the control module.
• From the spray gun.
• It is possible to powder-coat regardless of the menu in progress with the exception of the
“Cleaning” menu.
• The operator may return to the factory parameters at any time (see § 6.1 page 17).
• The operator may switch to a cleaning screen by pressing button 4 (regardless of the screen
displayed) for more than two seconds.
To Next Page
Loading...