Index revision : H 14 6336
Area 3
: This area is used for selecting pre-programmed voltage/current characteristics.
On start-up, a red LED lights up below the “round spray nozzle” icon and pressing the “U/I” button ena-
bles selection of one of the four characteristics.
WARNING : For guns sold in 2006, it will be then possible to display the " cleaning screen " by
pressing onto U/I key for 2 seconds. The output of this screen is similar to the input one.
If E screen mentions : “Mach-Jet V > or = 1” this function is available; if E screen mentions
“Mach-Jet V = 0”, the gun is not equipped with this function.
To Next Page
Loading...