Menu System
19
Explanation of Various System Settings
Auto Power Down
When Auto Power Down is turned “ON”, the display shall automatically switch from on
mode to full standby mode following 4 hours of inactivity (inactivity is defined as having
no user interaction/activation of the display control buttons or remote control for a
period of 4 hours). Once in full standby mode, to bring the panel back into operation the
user must activate any of the control buttons on the panel or use the remote control that
is included with the display (e.g. not the video conferencing system remote) in order to
reactivate the display.
Note that the default setting for Auto Power Down is “ON”, in compliance with
EU REGULATION (EC) No 642/2009. However, it is recognized that for video
conferencing applications, the display often requires the ability to sense incoming video;
and if the display has entered the power down state, presence of video will not activate
the display. Should Auto Power Down cause inconvenience, it is suggested that this
feature be disabled and set to ‘OFF’. This will ensure that the panel will automatically
come out of power save mode upon receiving an active video signal from the
conferencing system, and requires no further user interaction to reactivate the
display panel.
To Next Page
Loading...
Need help?
General
