Samson 373 Series - Resetting Diagnostic Parameters

5 Resetting diagnostic
parameters
When an alarm is issued, the source of the
error should be first located and the error
remedied.
In the case of an EXPERT alarm, we recom
-
mend reading the corresponding remedy
notes listed in the error code list (refer to the
Operating Instructions of the positioner).
Remedy notes on EXPERT
+
alarms are listed
in the table in section 7.
EXPERT
Alarms generated by EXPERT which are
indicated on the positioner display by an er-
ror code can be confirmed by pressing the
rotary pushbutton after selecting the corre
-
sponding error code.
Resetting error codes as well as resetting op
-
tions such as logging or the total valve travel
can be performed using an engineering
tool, for example, TROVIS-VIEW3 software.
EXPERT
+
Extended alarms generated by EXPERT
+
are
based upon the statistical information AUTO
and tests MAN. An active EXPERT
+
alarm is
indicated by Code 79 at the positioner.
Select
Diagnosis folder (> Status messages
> Reset ) to reset data from statistical infor
-
mation AUTO and tests MAN (see Fig. 15).
EB 8388 EN 31
Resetting diagnostic parameters
Fig. 15 · Resetting diagnostic parameters