Samson 373 Series - EXPERT + Without TROVIS-VIEW

8 EXPERT
+
without TROVIS-VIEW
The EXPERT
+
valve diagnostics are displayed in different ways depending on the type of
communication and the connected engineering tool.
The TROVIS-VIEW software with communication over the SSP interface provides full access
to EXPERT
+
diagnostic functions:
4
Numerical display of parameters
4
Display of parameters in the form of graphs
4
Parameterization, where applicable
The representation may differ in other engineering tools. The table below illustrates the differ
-
ences.
Communication HART – DD HART-DTM HART-EDD FF – DD Profibus-EDD
Engineering tool e.g. PACTWare e.g. Siemens PDM
Various Siemens PDM
Start reference test
(section 1.5)
•• • ••
Statistical information AUTO (refer to section 2 for description)
Data logger
No numerical
display
No graphical
display
•
No numerical
display
No graphical
display
No numerical
display
No graphical
display
•
Travel histogram ·
long-term
1)
No graphical
display
••
No graphical
display
•
Travel histogram ·
short-term
No graphical
display
No parame
-
terization
••–•
Setpoint deviation
histogram · long-term
1)
No graphical
display
••–•
Setpoint deviation
histogram · short-term
No graphical
display
No parame
-
terization
••–•
Cycle counter
histogram · long-term
1)
No graphical
display
••
No graphical
display
•
Cycle counter
histogram · short-term
1)
No graphical
display
••–•
Steady-state drive
signal · long-term
1)
No graphical
display
••–•
38 EB 8388 EN
EXPERT
+
without TROVIS-VIEW