Samson 3730-3 - Version for Single-Acting Actuator

56 EB 8389 EN
Statistical information
The results from the Statistical information
test can be checked by performing a test
from Tests (out-of-service diagnostics) if the
process allows it. See section5.2.
4.7.2 Resetting single status
messages
The messages 'Friction' and 'External leak-
age' are reset by the command "Reset 'Drive
signal diagram hysteresis'" or "Reset 'Drive
signal diagram hysteresis - short-term'".
By selecting and executing the command
"Reset 'Drive signal diagram hysteresis'", all
the measured data of the diagram, including
the short-term monitoring, are reset.
By selecting and executing the command
"Reset 'Drive signal diagram hysteresis -
short-term'", the measured data in the
'Short-term' folder are reset.
Operation > Reset
− Reset 'Drive signal diagram hysteresis'
− Reset 'Drive signal diagram hysteresis - short-
term'
Note