Samson 3730-3 - Heavy-duty version

64 EB 8389 EN
Tests
1.
Settings > Identication > Positioner > Actu-
ator
− Model: Single acting, [-/-]
2. − Booster: Not present, [-/-]
Dening parameters
1. Switch to manual mode.
2. Select classication for status messages.
3. Start test.
The 'Test information' status indicates
'Running test'. 'd1' and 'tEST' are indi-
cated in alternating sequence on the po-
sitioner display.
'Function check'
is activated as the
condensed state.
1.
Operation > Operating mode
1)
Target mode (Code 0): Manual
Types3730-2/-3/-4/-5 (1.5x) and Type3731-3:
2.
Settings > Positioner > Error control > Classi-
cation report > Extended > ...
Air supply
− Perhaps modied (TEST):
[
], , , ( ), ( )
− Perhaps not enough (TEST):
[
], , , ( ), ( )
− Working at full capacity (TEST):
[
], , , ( ), ( )
Leakage pneumatics
− Perhaps existing (TEST):
[
], , , ( ), ( )
− Perhaps too large (TEST):
[
], , , ( ), ( )
Actuator springs
− Spring stiffness may be reduced (spring fail-
ure) (TEST): [
], , , ( ), ( )
− Perhaps bias reduced (TEST):
[ ], , , ( ), ( )
− Working at full capacity (TEST):
[
], , , ( ), ( )
Type3730-5 (1.6x) and Type3731-5:
2.
Settings > Positioner > Diagnosis
conguration > Classication
− Air supply: [
], , , ,
− Leakage pneumatics: [ ], , , ,
− Actuator springs: [ ], , , ,
3. Start test
1)
Types3730-4/-5 and Type3731-5: Opera-
tion > Operating mode > Positioner (AO,
TRD)
Cancel the test by right-clicking 'Stop test'
and selecting 'Execute' or by pressing the ro-
tary pushbutton at the positioner.
After the test has been canceled, the posi-
tioner remains in manual mode.
In TROVIS-VIEW the test information and
progress ag of the test are displayed. The
'Test information' status indicates 'Test n-
ished' after the test is nished.
Every time the test is performed, old mea-
sured data are overwritten (Repetition).
Note
Note