Samson 3730-3 - Page 66

66 EB 8389 EN
START-UP
Requirements
– Model: Single acting
– Booster: Not present
– Target mode: Manual
â
Cancellation condition
Tolerance band of hysteresis
Status classication (NE107)
Friction
â
MANUAL MODE (TEST)
Start test
â
Reference test completed
(see section2.4.1)?
NO à
YES
â
First test = Reference
Start test
â
Test analysis
Friction:
Much higher/lower over whole range
Much higher/lower over section
â
Status classication (NE 107)/
logged by operating hours counter
Friction
â
Reset 'Drive signal diagram – hysteresis – measured data'
Tests – Drive signal diagram hysteresis