over twisted-pair cables conforming to
IEC 61158-2.
Note: In the case, complex functions are
started in the positioner, which require a
long calculation time or lead to a large
quantity of data being stored in the volatile
memory of the positioner, the alert “busy” is
issued over DD.
This alert is not a fault alarm and can sim
-
ply be confirmed.
Configuration using TROVIS-VIEW software
The positioner can be configured using
TROVIS-VIEW Configuration and Operator
Interface software.
The positioner is equipped with an addi-
tional digital SERIAL INTERFACE to connect
the RS-232 or USB port of the computer to
the positioner over an adapter cable.
The TROVIS-VIEW software enables the user
to easily set parameters in the positioner
and view process parameters online.
Configuration using the NI-FBUS™
Configurator
The NI-FBUS™ Configurator from National
Instruments can also be used to configure
the positioner. For this purpose, an interface
card must be installed in a computer to con
-
nect it to the F
OUNDATION™ fieldbus.
The integrated function blocks are linked
using the NI-FBUS™ Configurator.
14 EB 8384-5 EN
Design and principle of operation
To Next Page
Loading...
