Samson 3730-5 - Operation; Enabling and selecting parameters; Operating modes

8 Operation
WARNING!
The actuator stem moves while the positioner
is being operated.
Do not touch the actuator stem or obstruct it
to avoid risk of injury to hands or fingers.
8.1 Enabling and selecting
parameters
The codes which are marked with an aster
-
isk (*) in section 17.1 on page 90 onwards
must be enabled with Code 3 before the as
-
sociated parameters can be configured as
described below.
Code 3
Configuration
not enabled
Configuration
enabled
Turn
→
Code 3, display: OFF
Press , Code 3 blinks.
Change the setting of Code
3 .
Turn
→
ON
Press , display:
The configuration is enabled.
You can now configure codes one after the
other:
Turn and select the required code.
Press to access the selected code. The
code number starts to blink.
Turn and select the setting.
Press to confirm the selected setting.
Note: If no settings are entered within 120
seconds, the enabled configuration function
becomes invalid and the display changes to
Code 0.
Cancel the setting:
Canceling the setting
To cancel a value before it is confirmed (by
pressing ) proceed as follows:
Turn
→
ESC
Press . The entered value is not adopted.
8.2 Operating modes
8.2.1 Automatic and manual
modes
After initialization has been completed suc
-
cessfully, the positioner is in automatic
mode.
EB 8384-5 EN 65
Operation