Samson C-Control User Manual

16
Stacking and Tilting the C•control
Installing the Tilting Feet
You can install the tilting rubber feet included with
your C control so that you can set the unit at a
comfortable operating angle on a workstation or
desktop. Follow the simple instructions below to
install the tilting feet.
• Remove the bottom screw from right front
bumper.
• Identify the right tilting foot by the locating
“R” marking on the inside top.
•Position the angled foot under the right
bumper as shown in the drawing.
• Use the included 4 x 10mm screw to attach
the foot.
• Repeat the steps above for the front left
bumper.
K
M
IC
TALK TO
2TK
TALK TO
CUE
1
0
CONTROL ROOM
MATRIX
SAMSON
B
ACK
Stacking the C•control
You can stack one C control,
or any other Samson C Class
units, on top of each other by
simply lining up the bumpers.
Impor
tant Note: When stacking
the C control, be sure that only
the bottom unit has the tilting
feet installed.
• Remove the bottom screw from right front bumper.
• Identify the right tilting foot by the locating “R” marking on the inside top.
•Position the angled foot under the right bumper as shown in the drawing.
MIX 2TK A
2TK C
2TK B
OL
+6
0
-6
-18
-30
LR
SPEAKER A SPEAKER C
MUTE
SPEAKER B
SUB
DIM
MONO
HEADPHONE
VOLUME
SPK B
VOLUME
HEADPHONE
VOLUME
0 10
0
10
0
10
TAL KBACK
LEVEL
MIC
TALK TO
2TK
TALK TO
CUE
0 10
CONTROL ROOM
MATRIX
SAMSON
SOURCE
DESTINATION
LEVEL
CONTROL ROOM
TALKBACK
MIX 2TK A
2TK C
2TK B
OL
+6
0
-6
-18
-30
LR
SPEAKER A SPEAKER C
MUTE
SPEAKER B
SUB
DIM
MONO
HEADPHONE
VOLUME
SPK B
VOLUME
HEADPHONE
VOLUME
0 10
0
10
0
10
TAL KBACK
LEVEL
MIC
TALK TO
2TK
TALK TO
CUE
0 10
CONTROL ROOM
MATRIX
SAMSON
SOURCE
DESTINATION
LEVEL
CONTROL ROOM
TALKBACK

Samson C-Control Specifications

General

Brand	Samson
Model	C-Control
Category	Recording Equipment
Language	English