Samson EB 2111 - Page 12

1-8 EB2111/2121/2123 EN
Safety instructions and measures
NOTICE
!
Risk of the process medium being contaminated through the use of unsuitable lubri-
cants and/or contaminated tools and components.
Î Keep the regulator and the tools used free from solvents and grease.
Î Make sure that only suitable lubricants are used.
Risk of excess pressure damaging plant sections due to construction-related seat
leakage through the regulator.
Î Always install a safety device (e.g. safety excess pressure valve or safety relief
valve) in the plant.
Risk of irreparable regulator damage caused by the regulator components being
taken apart.
The control thermostat is an inseparable hydraulic unit consisting of a control thermo-
stat, capillary tube and temperature sensor. If these components are dismantled (e.g.
removal of the capillary tube), the regulator will be irreparably damaged and will no
longerbeabletofulllitscontroltask.
Î Do not dismantle the regulator.
Î Only perform allowed activities on the regulator.
Î ContactSAMSON'sAfter-salesServicebeforereplacingspareparts.
SAMSON's After-sales Service can support you concerning lubricant, tightening torques
and tools approved by SAMSON.
Note