Samson EB 2111 - Installing the Control Thermostat; Installing the Reversing Device

EB2111/2121/2123 EN 5-7
Installation
4. Makesurethatthecorrectangegaskets
are used.
5. Bolt the pipe to the valve free of stress.
5.4.2 Installing the control
thermostat
Detailed instructions to install the control
thermostats are given in uEB2231.
1. Fasten the operating element of the con-
trol thermostat on the valve using the
coupling nut.
If necessary, use the set point adjuster to
adjust the highest possible set point,
causing the pin of the operating element
to retract.
Observethespeciedtighteningtorques
(see 'Tightening torques' in Annex).
2. If applicable, mount the thermowell.
Insert the thermowell in the socket in-
stalled on site.
Observethespeciedtighteningtorques
(see 'Tightening torques' in Annex).
Note
5.4.3 Installing the reversing
device
Î See Fig.5-5
The reversing device (for Type4u) can only
be attached to the valve when the stem is ful-
ly retracted.
The spring (8) of the reversing device is pre-
tensioned upon delivery over the lever (4)
using a wooden bolt (5) with washer (6) and
coupling nut (7).
Procedure
1. Screw the pretensioned reversing device
to the bottom section of the valve.
2. As the device is pretensioned, carefully
unscrew the coupling nut (7) and remove
it from the reversing device together with
the wooden bolt (5) and washer (6).
3. Adjust the highest possible set point at
the set point adjuster to cause the pin of
the operating element to retract.
4. Screw the operating element onto the re-
versing device (in place of the coupling
nut (7)).
Keep the wooden bolt and washer for later
use.
They can be used, for example to pretension
the reversing device again if it needs to be
reinstall after disassembly.
Note
Note