Samson EB 2111 - Notes on Possible Property Damage

EB2111/2121/2123 EN 1-7
Safety instructions and measures
1.3 Notes on possible property damage
NOTICE
!
Risk of regulator damage due to incorrectly attached slings.
Î Do not attach load-bearing slings to the control thermostat (see information under
'Lifting the regulator' in the 'Shipment and on-site transport' section).
Risk of regulator damage due to unsuitable medium properties.
Theregulatorisdesignedforaprocessmediumwithdenedproperties.
Î Onlyusetheprocessmediumspeciedforsizingtheequipment.
Risk of regulator damage due to contamination (e.g. solid particles) in the pipeline.
The plant operator is responsible for cleaning the pipelines in the plant.
Î Flush the pipelines before start-up.
Risk of regulator damage due to the use of unsuitable lubricants.
The lubricants to be used depend on the regulator material. Unsuitable lubricants may
corrode and damage surfaces.
Î Only use lubricants approved by SAMSON.
When in doubt, consult SAMSON.
Risk of leakage and regulator damage due to excessively high or low tightening
torques.
Observethespeciedtorqueswhentighteningregulatorcomponents.Excessivetight-
ening torques lead to parts wearing out more quickly. Parts that are too loose may
cause leakage.
Î Observethespeciedtighteningtorques(see'Tighteningtorques'inAnnex).
Risk of regulator damage due to the use of unsuitable tools.
Certaintoolsarerequiredtoworkontheregulator.
Î Only use tools approved by SAMSON.
When in doubt, consult SAMSON.