Samson TROVIS 3730-1 - 10.1 Resetting error codes; 10.2 Error codes

EB 8484-1 EN 91
Malfunctions
10.1 Resetting error codes
The E0 and E3 to E8 error codes can be reset as follows:
1. Turn to select the error code.
2. Press
, ESC is displayed. The error code blinks.
3. Turn
until RST appears.
4. Press
to reset the error.
The reset procedure can be canceled by pressing rotary pushbut-
ton while ESC is displayed.
10.2 Error codes
TheerrorslistedinTable17areassignedtoerrorclasses:
− Error class 1: No operation possible
− Error class 2: Manual operation only possible
− Error class 3: Manual operation and closed-loop control possible
InTROVIS-VIEW,anadditionaliconforstatusclassicationisshowntogetherwiththeerror
(seeTable16).
Î If other malfunctions other than those listed in this section occur, contact SAMSON's
After-salesServicedepartment(seesection12.1).
Table16: Icon showing status classication
Icon Meaning
Failure
Function check
Outofspecication
Maintenance demanded
No message