English 11
NOTE
• Set Model Selection and Temp. Unit, using the provided
instructions.
• The remote control works properly when Model Selection and
Temp. Unit are set correctly.
• If the remote control battery discharges, this function is canceled.
in this case, run this function again.
• To change the model or temperature unit, use the following
procedure:
▶ ▶
Select
Settings
.
▶
▶ ▶
Select
Model Selection
▶
or
Temp. Unit
.
Setting Heating Range
You can change the temperature setting range to Heat mode.
In
operation
▶
▶ ▶ Select Settings.
▶
▶ ▶
Select Heating
Range.
▶
▶ ▶
Select Low
Ambient.
▶
NOTE
• The temperature control range in Heat mode changes 8 ℃ to
30 ℃ (47 ℉ to 86 ℉). Select this mode if using the Low Ambient
model that supports control settings.
• If the system is not a low ambient heating model and the low
ambient setting is enabled on the wireless controller, the indoor
unit heating set point will not allow the user to set it as low as the
controller allows.
Heating
Range
To Next Page
Loading...
