Samsung CLX-6220 - Error 08-002;006: Original Paper Jam (Scanner Path)

Alignment & Troubleshooting
Service Manual
4-47
Samsung Electronics
● Code
08-002
08-006
● Error message
Original paper jam inside of scanner
● Symptom and Possible Cause
The leadedge of the document has not reached to scan sensor after being sensed by the regi sensor.
● Possible Cause
1. Gate sensor or actuator is defective.
2. Document paper path is contaminated.
3. WHITE BAR SHEET is not attached properly.
4. WHITE BAR is defective.
● Troubleshooting method
1. Check the paper path for a small piece of paper that may have been torn from an original; or foreign materials
such as paper clips, extracted staples, etc.
2. Check that the White bar sheet is properly set to the guide.
3. Check and clean the Registration Roller, replace as is necessary.
4. Check and clean the Exit Roller, replace as is necessary.
5. Check and clean the Scan Senor for paper dust, replace as is necessary.
6. Check the signals from the Scan Sensor Drive Board, replace as is necessary.
7. Check and clean the Exit Solenoid, replace as is necessary.