1.2 Caution for safety
1.2.1 Toxic material
This product contains toxic materials that could cause
(1) If the LCD control panel is damaged it is possible f
with the skin should be avoided. Wash any splash
doctor. If the liquid gets into the mouth or is swallo
(2) Please keep Drum cartridge and Toner cartridge a
Drum cartridge and Toner Cartridge may be harmf
1.2.2 Electric shock and fire safety
Failure to follow the following instructions could cause
(1) Use only the correct voltage, failure to do so could
cable to overheat and potentially cause a fire.
(3) Do not overload the power socket, this could lead t
lead to a fire.
(4) Do not allow water or other liquids to spill into the p
paper clips, pins or other foreign objects to fall into
to an electric shock or fire hazard.
When servicing the printer remove the power plug
(6) Use caution when inserting or removing the power
firmly and pull. The power connector must be inser
overheating possibly leading to a fire.
(7) Take care of the power cable. Do not allow it to be
damaged. Do not place objects on top of the powe
overheat and cause a fire. Exposed cables could c
cable immediately do not reuse or repair the dama
the power cable, weakening the cover or exposing
(8) Ensure that the power sockets and plugs are not cr
should be repaired immediately. Take care not to c
the machine.
(9) Use caution during thunder or lightning storms. Sa
from the power source when such weather conditi
ower cord if it is still connected to the wall socket
(10) Avoid damp or dusty areas, install the printer in a
machine near a humidifier or in front of an air con
can lead to overheating and cause a fire or cause
(11) Do not position the printer in direct sunlight. This
possibly leading to the printer failing to work prop
(12) Do not insert any metal objects into the machine t
could make contact with a high voltage conductor
Service Manual
CLX-9250/9350 series
1
r the liquid inside to leak. This liquid is toxic. Contac
s from eyes or skin immediately and contact your
ed see a doctor immediately.
ay from children. The toner powder contained in the
l and if swallowed you should contact a doctor.
lectric shock or potentially cause a fire.
amage the printer and potentially cause a fire or
Use of an incorrectl
ecified cable could cause the
overheating of the cables inside the wall and could
rinter, this can cause electric shock. Do not allow
the printer these could cause a short circuit leading
ble with wet hands, this can cause electric shock.
onnector. When removing the power connector, grip it
ed completely, otherwise a poor contact could cause
ome twisted, bent sharply around corners or wise
cable. If the power cable is damaged it could
use an electric shock. Replace the damaged power
aged cable Some chemicals can attack the coating on
cables causing fire and shock risks.
cked or broken in any way. Any such defects
ut or damage the power cable or plugs when moving
sung recommends that this machine be disconnected
ns are expected. Do not touch the machine or the
n these weather conditions.
lean well ventilated location. Do not position the
itioner. Moisture and dust built up inside the machine
parts to rust.
ill cause the temperature inside the printer to rise
rly and in extreme conditions could lead to a fire.
rough the ventilator fan or other part of the casing, it
inside the machine and cause an electric shock.
SAMSUNG ELECTRONICS