Samsung CLX-9350ND - Halogen Lamp

3. Replaceme
n
3.5.4 Halogen Lamp
Perform the following procedure to remove the Halog
e
[E]
[F]
[G]
Service Manual
CLX-9250/9350 series
3-
3
n
t Procedures
1. Remove the Fuser top, NC thermistor holder (refer
e
n lamp from the Fuser Unit.
to 3.5.1) and Motor (refer to 3.5.3)
2. Take off the support lever belt [E] after removing 2
screws.
3. Take off the frame fuser front [F] after removing 3
screws.
4. Remove the holder harness [G] rear after
removing 2 screws.
5. After 4 step, release the harness from the
holder harness.
CAUTION
Be careful not to damage in harness.
The damage of the harness can make a fire
caused by a short circuit.
SAMSUNG ELECTRONICS
3
4